HOW TO INSTALL LIGHT GUARD COVERS ON YOUR JEEP WRANGLER

September 06, 2021 2 min read

If you travel on rough roadways or rough routes, you need to protect your Jeep Wrangler from dirt and also debris. You can safeguard your LED taillights-- and also individualize your Jeep at the same time-- by installing light guard covers on your lorry. If you assume you might intend to include these valuable features to your vehicle, read below to discover how to mount light guard covers on your Jeep Wrangler.

ACTION 1: REMOVE FOUR SCREWS WITH PHILLIPS SCREWDRIVER

To install your brand-new Jeep Wrangler taillight covers, you first require to get rid of the old ones from your automobile. To do this, eliminate the four screws that affix the old cover to the taillight with a Phillips-head screwdriver. Make certain to keep this tool out of the toolbox due to the fact that you'll need it once again for step three.

STEP 2: REMOVE THE OLD TAILLIGHT COVER

After you eliminate the screws, it's time to get rid of the old taillight cover. This is straightforward sufficient; all you need to do is lift the old cover carefully off the taillight. It should be simple if you've kept in mind to remove all the screws.

STEP 3: ATTACH YOUR NEW TAILLIGHT COVER

The next step is to attach the brand-new taillight cover. Very carefully place the brand-new cover over the headlight and also utilize your Phillips-head screwdriver to connect the 4 new screws. Make certain the screws are not too limited or loosened. If they are as well loose, the light guard cover might fall while you're driving. If they are as well limited, you can damage the Jeep as well as the light guard cover.

STEP 4: REPEAT THE PROCESS
You have actually currently efficiently installed a light guard cover on one taillight. Currently, you just require to replace the light guard cover on the various other taillight. It may look a little odd if you mount only one light guard cover!

These actions teach you exactly how to mount light guard covers on your Jeep Wrangler. Prior to you go off-roading or driving on rough backroads, safeguard your LED taillights with light guard covers.

You can protect your LED taillights-- and also customize your Jeep at the very same time-- by mounting light guard covers on your car. If you assume you may desire to add these valuable features to your truck, checked out below to discover just how to set up light guard covers on your Jeep Wrangler.

If they are as well limited, you could damage the Jeep and also the light guard cover.

You have actually currently effectively set up a light guard cover on one taillight.

HanPolly
HanPolly


Leave a comment

Comments will be approved before showing up.


Also in LED Light

2018 Jeep Wrangler Taillights

October 11, 2021 2 min read

2018 Jeep Wrangler The First Official Images

October 08, 2021 2 min read

8 Points You Need To Know About Jeep Gladiator Bed Tents

October 08, 2021 2 min read